Table of Contents
Advertisement
INSTALLATION
COMMUNICATION CABLE INSTALLATION
The communications cable should be hanging loose on the
outside of the cooler.
Feed the communication cable through the rear access hole in
the underside of the tank.
UNDERSIDE VIEW
Route the communication cable across the cable tray on the
inner wall of the tank, and then up to the controls module.
TOP VIEW
Plug the communications cable into either of the RJ12 sockets
labelled "Comms".
DRAIN VALVE CABLE
WALL CONTROL CABLE
ILL3029-B
Secure the power and communication cables in the rear access
hole slot and insert the plug provided to seal the hole.
ILL3109-A
ILL3110-A
INSTALLATION
CONNECTIONS
UNDERSIDE VIEW
859741-L CW3 INSTALLATION MANUAL
ISOLATION
SWITCH
ILL3111-D
ILL3111-D
ILL3112-A
| 15
Advertisement
Table of Contents
