Appendix B: 'Piece By Piece' Installation - Seeley CW3 Installation Manual

APPENDIX B: 'PIECE BY PIECE' INSTALLATION

The 'piece by piece' installation method should be employed as
a secondary option when installation by crane is too difficult or
not feasible.
Important! If using this method, it is imperative that the
disassembly and reassembly instructions are followed carefully.
If the cooler is not correctly reassembled, the customer may
experience a performance penalty in terms of cooling capacity
and cooling effectiveness. It is the installer's responsibility to
ensure that the cooler is reassembled correctly according to
the following instructions. During disassembly/reassembly, be
vigilant and ensure all fasteners and small components are
stored in containers for safe keeping.
Initial disassembly on the ground:
Remove all 8 side panel clips, all 4 top clips and all 4 side panel
assemblies. This will require a flat head screw driver. Store the
clips in a container.
Remove the lid grille by loosening all 8 of the encapsulated
wing nut lid screws and then lifting the lid upwards. The lid
screws are encapsulated and should not separate from the lid if
untightened uniformly.
Unclip the spreader hoses and then pull and release the top
manifold retention straps.
34 | 859741-L CW3 INSTALLATION MANUAL
ILL2788-A
ILL2788-A
SPREADER
HOSES
ILL3032-A
RETENTION
STRAP TOP
ILL3033-A
Release the bottom manifold retention straps.
The manifold assembly can now be pulled directly outwards.
Cooler with manifolds removed.
ILL3033-A
ILL3034-A
ILL3130-A