Table of Contents
Advertisement
APPENDIX B: 'PIECE BY PIECE' INSTALLATION
Plumb and connect all hoses to the manifold assemblies as
shown. Inner hoses (grey) are to be connected to the upper
manifold connection point. Outer hoses (blue) are to be
connected to the lower manifold connection point.
Important! It is imperative that the water distribution hoses
are connected correctly.
Transport the lid to the roof and reinstall. Tighten all 8 lid screws
uniformly and adequately.
Transport the side panel assemblies to the roof. To reinstall all
4 side panel assemblies, rest the bottom lip of the side panel on
the tank guide ribs and engage the clips on an angle as shown.
Mate the top edge of the side panel with the lid and press fit
along the top surface. The panel will lock into place with the
lid. For installation of successive side panels, ensure side ribs
are neatly interfacing. These can be pressed in with moderate
force.
40 |
859741-L CW3 INSTALLATION MANUAL
Once all 4 side panels are fitted, refit all 8 side clips and all 4
top clips.
ILL2816-A
ILL2817-A
ILL2818-A
ILL2819-A
Advertisement
Table of Contents
