Presto Lifts LIFT-STIK Owner's Manual page 6

Pre-start Inspection - Before use each day or at the beginning of each shift, the machine shall
be given a visual inspection and functional test including but not limited to the following:
1. Operating and emergency controls
2. Safety devices
3. Electrical cables and wiring harness
4. Loose or missing parts
5. Nameplates, precautionary and instructional markings and/or labeling
6. Guarding system
7. Items specified by the manufacturer
Problem or Malfunctions - Any problems or malfunctions that affect the safety of operations
shall be repaired prior to the use of the machine.
Before Operations - The operator shall:
1. Read and understand the manufacturer's operating instruction(s) and user's safety rules
or have them explained.
2. Understand all labels, warnings, and instructions displayed on the machine or have
them explained.
Workplace Inspections - Before the machine is used and during use, the operator shall check
the area in which the machine is to be used for possible hazards such as, but not limited to:
1. Bumps, floor obstructions, and uneven surfaces
2. Overhead obstructions and electrical hazards
3. Presence of unauthorized persons
4. Other possible unsafe conditions as noted in the operating manual.
Operator Warnings and Instructions - The operator shall ensure the operation of the
machine is in compliance with the following:
1. Guarding system - Guarding shall be installed and positioned, and access gates or
openings shall be secured per the manufacturer's instructions (If applicable).
2. Distribution of load - The load and its distribution on the platform shall be in
accordance with the manufacturer's rated capacity for that specific configuration.
3. Maintaining overhead clearance - The operator shall ensure that adequate clearance
is maintained from overhead obstructions and energized electrical conductors and parts.
4. Point of Operation - The operator shall not place any part of their body under the
platform.
5. Precaution for moving equipment - When other moving equipment or vehicles
are present, special precautions shall be taken to comply with the safety standards
established for the workplace.
6. Reporting problems or malfunctions - The operator shall immediately report to a
supervisor any problem(s) or malfunction(s) that become evident during operation. The
operator shall ensure all problems and malfunctions that affect the safety of operations
are repaired prior to continued use.
7. Capacity limitation - Rated capacity and load center shall not be exceeded when loads
are transferred to the platform.
Presto Lifts 6 PLS67-285 Manual