Table of Contents
Advertisement
2.4
General Safety Precautions During Use
General safety precautions during use
The following guidelines must be observed and followed when using a lift, to prevent personal injury:
Under no circumstances should the lift elevate more than specified on the label.
l
It is of most importance, due to personal safety, that the specified weight, load position,
l
and height are respected and that the lift is not overloaded.
The lift must not be used for lifting persons.
l
No body parts near the sledge or tool at the mast or other lifting equipment when operated
l
up/down.
Ensure that there is no person below the load, tool and lift when operated.
l
There should be no body parts on top of the front legs steel profile, when the lift is elevated
l
or operated.
Only one person must operate the lift at a time.
l
The user must read and understand these instructions or must have them explained to
l
them before using the lifter.
Only use the lift when operated on a hard level surface during lifting or transporting loads.
l
When transporting cargo, the load should be lowered to the lowest possible position and
l
secured in order to ensure that the cargo cannot slide.
Always secure the cargo on the lift when moving.
l
Note when not in use or storing, always ensure that the sledge is lowered to the lowest
l
possible position and is free of any items or cargo.
Operate and store in a clean, dry location with temperature from +5 °C to +40 °C.
l
Make sure that the tool is firmly attached to the sledge and no slack occurs in the bolt
l
connection.
The lifter is to be inspected at least once a year or according to laws, regulations,
l
directives, working conditions and experience. The inspection shall be performed by the
manufacturer or a skilled technician. Please check your local requirements.
Do not lift or handle open containers containing corrosive fluids, harmful to people if
l
spilled.
Industrial or commercial use only.
l
Indoor use only.
l
Do not use the lifter in explosive or flammable hazard environment.
l
Do not use or store in a corrosive environment.
l
The load's center of gravity to be no further than 15.7in/400 mm from the mast.
l
The lifter should only be cleaned by wiping with a damp cloth, otherwise water may
l
enter into contacts and control panel.
The cam belt should be replaced every 8 years.
l
Presto Lifts
12
PLS67-285 Manual
Advertisement
Table of Contents
