Table of Contents
Advertisement
8
Cleaning Instructions
Cleaning instructions
Swap batteries
l
The external battery swap unit must be removed from the lifter, prior to cleaning.
Model-approved IP code:
Solid particle protection
Liquid ingress protection
(with batteries)
Always wear the correct safety equipment
l
Lower the lifting tool, so that you don't risk a head injury when cleaning near the floor.
l
The battery charger must be disconnected from the main during cleaning.
l
In case of remote control the plug on the mast must be protected during cleaning.
l
Presto Lifts
Ingress protection marking (IP)
IP 41
IP 4X
IP X1
Special instructions/Precautions
Detergent application
Use a standard PH neutral
l
cleaning detergent.
The outer surfaces can be
l
cleaned using a wet brush
or a damp cloth.
Key inspection points
Test that all functions are working properly before the lifter is placed back into
l
service.
IP code description
>1 mm
Most wires, slender screws, large ants etc.
Dripping water Dripping water (vertically falling drops)
shall have no harmful effect on the spe-
cimen when mounted in an upright position
onto a turntable and rotated at 1 RPM.
Do not use Acid, Alkaline or harsh chem-
l
ical products, these might weaken the
drive belt and other sensitive com-
ponents or leave marks on the surfaces.
Work process
Do not use liquids to clean the lifter as
l
this may have adverse effect on the elec-
trical components.
29
PLS67-285 Manual
Advertisement
Table of Contents
