Replacing Parts and Supplies
7.3
Empty the Hole Punch Waste Container
If the punch kit is installed in the finisher FN-8, the message "Remove
Punch Scraps" will appear when the hole-punch waste container is full.
To empty the hole-punch waste container
Empty the hole-punch waste container, and then re-install it according to
the following procedure.
1
Slide the finisher away from the
copier.
2
Pull out the hole-punch waste
container.
3
Empty the container.
4
Insert the hole-punch waste
container into its original position.
5
Slide the finisher back against the
copier.
d-Color MF 20
7
7-11