Minolta d-Color MF 20 Manual page 40

3
No. Part Name
8 Original Cover OC-2
(optional)
9 Duplex Unit AD-14 (optional)
10 Paper Feed Unit
PF-118 (optional)
11 Copy Table CT-2 (optional)
12 Finisher FN-8 (optional)
3-16
13
12
Description
Presses down on the loaded document to keep it in
place
Referred to as the original cover throughout the
manual
Turns over copies, allowing double-sided copies to
be made automatically.
• If a printer controller (Fiery X3e 31C-M) and the
Referred to as the duplex unit throughout the
manual
Equipped with a paper drawer that can supply 500
sheets of paper; up to two paper feed units can be
installed.
Referred to as the paper feed unit throughout the
manual
A paper feed unit can be set up on the copy table,
and then the printer can be set up on the top.
By setting up the printer on the copy table, the printer
can be placed on the floor instead of on a desk,
keeping the entire surface of the desk free.
Referred to as the copy table throughout the
manual
Finishes copies according to the selected Finishing
setting (sorting, stapling, hole-punching or booklet
binding), then feeds out the pages
• The hole-punching function is only available if the
Features and Components
duplex unit are installed, the memory must be
expanded. If the optional memory is not installed,
automatic double-sided copying cannot be
performed.
optional punch kit (PK-4) is installed onto finisher
FN-8. If the finisher is installed, the printer must
be installed on the copy desk, on the large
capacity cabinet or over a paper feed unit
combined with the copy table.
8
9
10
11
d-Color MF 20