Minolta d-Color MF 20 Manual page 41

Features and Components
No. Part Name
13 Copier Stand CS-2 (optional)
14 Punch KIT PK-4 (optional)*
15 Memory M256-2 (optional)*
16 Hard Disk Drive HDD-5
(optional)*
17 Printer Controller
CPC 31C-M (optional)*
18 Printer Controller
Fiery X3e 31C-M (optional)*
* The internal options are not shown.
d-Color MF 20
Description
Reduces the installation area required for the
equipment if the scanner is installed on the top of the
stand and the printer is installed on the inside
Referred to as the copier stand throughout the
manual
Allows the hole-punching function to be used if
installed onto finisher FN-8
Increases the memory of the copier to 512 MB (256
MB standard memory + 256 MB expanded memory)
By expanding the memory, the number of pages that
can be stored in the memory can be increased.
(Refer to Supplemental Table 1.)
Referred to as the memory throughout the manual
By installing the hard disk, the "Distribution" function
can be used. In addition, the number of pages that
can be stored in the memory can be increased.
(Refer to Supplemental Table 1.)
Internal printer controller that allows the copier to be
used as both a color printer and a color scanner
configured into a computer network
For more details, refer to the manual of the printer
controller.
Stationary printer controller that allows the copier to
be used as both a color printer and a color scanner
configured into a computer network
For more details, refer to the manual of the printer
controller.
3
3-17