Table of Contents
Advertisement
Data Flash Strobe
06) With the menu
choose Smooth or Fast.
07) In the menu
08) Press the UP/DOWN buttons to choose between 10, 20, 30 or 60 seconds. If you choose the option
"ON", the display will remain continuously ON, when no button is pressed.
09) The last option
10) Press the SETUP button to open the menu and then press the UP/DOWN buttons to choose Yes or No.
11) Press the SETUP button again to confirm your choice. If you have chosen Yes, the factory settings will
be restored.
8. Info
01) Press the MODE button and then the UP/DOWN buttons, until the display shows
02) Press the SETUP button to open the menu.
03) Press the UP/DOWN buttons to choose between the 2 options,
04) Press the SETUP button to open one of the 2 options.
05) In the menu
06) In the menu
Ordercode: 40296
, you can set the dimmer speed, by pressing the UP/DOWN buttons. You can
you can set how long the display will remain ON, when no button is pressed.
is for resetting the device to the factory settings.
, the device will display if the temperature from the device is too high or not.
you can view the current software version.
17
.
and
.
Advertisement
Table of Contents
Need help?
Do you have a question about the Data Flash Strobe V1 and is the answer not in the manual?
Questions and answers