Intel Arria 10 FPGA User Manual page 17

3. Development Board Setup
683526 | 2023.07.12
Table 11. SW6 DIP Switch Default Settings (Board Bottom)
Switch Board Label
1 CLK_SEL
2 CLK_EN
3 Si516_FS
4 FACTORY
5 RZQ_B2K
Send Feedback
Function
ON for 100 MHz on-board clock oscillator selection
OFF for SMA input clock selection
OFF for setting
CLK_ENABLE
ON for setting the SDI REFCLK frequency to 148.35 MHz
OFF for setting the SDI REFCLK frequency to 148.5 MHz
ON to load factory image from flash
OFF to load user image #1 from flash
ON for setting RZQ resistor of Bank 2K to 99.17 ohm
OFF for setting RZQ resistor of Bank 2K to 240 ohm
signal high to the MAV V
® ®
Intel Arria 10 FPGA Development Kit User Guide
Default Position
ON
OFF
OFF
ON
OFF
17