Setting Paper On The Bypass Tray - Ricoh Aficio AP900 Operating Instructions Manual

Paper and Other Media
❒ For the left stack, align the left edge of the print paper with the left edge of
the tray.
Specifying the paper type
When you load translucent paper or thick paper, set the paper type. For details
about paper type, see

Setting Paper on the Bypass Tray

This section gives instructions for setting paper on the bypass tray. Use the by-
pass tray to print onto OHP transparencies, labels, thick paper, and envelopes
that cannot be loaded in the paper tray.
❒ When loading letterhead paper, pay attention to its orientation.
❒ Paper within the following dimensions can be set in the bypass tray:
• Vertical: 100.0 - 305.0 mm (3.9 in. - 12.0 in.)
• Horizontal: 139.7 - 458.0 mm (5.5 in. - 18.0 in.)
❒ With the RPCS or PostScript 3, when you load the paper onto the bypass tray,
load it according to the orientation set on the machine.
❒ With the RPDL, when you load the paper onto the bypass tray, load it in the
long-edge feed direction.
❒ Select or set the paper size using the control panel or the printer driver. When
loading custom size paper, see
❒ When loading OHP transparencies or thick paper in the bypass tray, make the
paper setting using the control panel or printer driver.
❒ The number of sheets that can be loaded in the bypass tray depends on the
paper type.
❒ The following functions are disabled when printing from the bypass tray:
• printing
• Auto Tray Switching
• Rotating Collate
• Staple (when the optional unit is installed)
• Punch (when the optional unit is installed)
❒ Be sure to set the paper size using the printer driver when printing data from
the computer. The paper size set using the printer driver has priority over the
size set using the display panel.
❒ Be sure to set paper print side up on the bypass tray.
p.64 "Specifying the paper
p.75 "Specifying custom size
type".
paper".
72