Ricoh Aficio AP900 Operating Instructions Manual page 93
Ricoh ap900: supplementary guide
Hide thumbs
Also See for Aficio AP900:
- Software manual (308 pages) ,
- Operating instructions manual (451 pages) ,
- Manual (12 pages)
Table of Contents
Advertisement
Troubleshooting
Messages/Second mes-
sages
Remove Paper
inside Finisher
Remove Paper
inside Finisher
Replace Charger
Replace Cleaning
Felt soon
Replace
Development Unit
Replace Fusing
Unit
Replace PCU
Replace Transfer
Belt
Replace Waste
Toner
Reset Tray #
or Form Feed
Reset Tray #
or Form Feed
Load Paper
Paper Type:
SC XXX-X
Power Off On
Call Service if
error reoccurs
SD authenticatn.
failed
Causes
Paper left in Finisher.
Paper left in Finisher.
(Booklet)
It is time to replace the
Charger.
Cleaning felt is almost
worn out.
It is time to replace the De-
velopment Unit.
It is time to replace the
Fusing Unit.
It is time to replace the
Photoconductor Unit.
It is time to replace the
Transfer Belt.
It is time to replace the
waste toner.
The indicated paper input
tray is not set correctly, or
is not set.
There is a problem with
the tray.
The Service Code or SC
number indicates the prob-
lem.
Authentication from the
SD card has failed.
Solutions
Open Finisher cover and remove pa-
per.
See
p.118 "Remove Misfeed R: Fin-
isher".
Open Finisher cover and remove pa-
per.
See
p.118 "Remove Misfeed R: Fin-
isher".
Call your service provider as soon as
possible.
Call your service provider as soon as
possible.
Call your service provider as soon as
possible.
You can still print even if this mes-
sage appears , but to ensure a good
standard of printing, call your service
provider as soon as possible.
Call your service provider as soon as
possible.
Call your service provider as soon as
possible.
Call your service provider.
Set the indicated paper input tray
correctly.
Load the tray with the correct paper
or change the paper type/size using
the dial or via the Paper Input menu
on the operation panel. Alternatively,
select another tray using {Form
Feed}, or cancel the job.
Turn the power switch to Standby,
and then to ON.
If the message appears again, call
your service provider. Report the er-
ror code that appears.
Turn the power switch to standby,
and then ON. If the message is dis-
played again, call your service pro-
vider.
93
Advertisement
Table of Contents
Troubleshooting
