Ricoh Aficio AP900 Operating Instructions Manual page 91

Troubleshooting
Messages/Second mes-
sages
Hardware Problem
HDD
Hardware Problem
Interposer
Hardware Problem
LCT
Hardware Problem
Parallel I/F
Hardware Problem
Printer font
Hardware Problem
Staple Unit
Hardware Problem
USB
Hardware Problem
Wireless Board
Invalid Password
Try again
Load Paper
or Form Feed
Load Paper
or Form Feed
Paper Size:
Paper Type:
Menu Protected
Cannot change
Causes
The printer identified an
HDD Board error.
The interposer has a mo-
tor problem..
LCT has a problem with
the transfer motor.
The printer identified an
parallel interface error.
Problems with the font file
for the print module.
The Staple Unit is not
functioning.
The printer identified a
USB I/F Board error.
Access to the IEEE
802.11b board is possible,
but an error was detected.
The invalid password was
entered and Locked Print
is incorrect.
No paper remaining in the
indicated tray.
The printer detected that
the actual paper type and
size in all trays are not the
same as the paper tray
size and paper type setting
when Auto Paper Select
mode is selected.
The operation panel has
been digitally locked, and
settings cannot be
changed.
Solutions
Call your service provider.
Turn the power switch to standby,
and then ON. If the message ap-
pears again, call your service provid-
er.
Turn the power switch standby, and
then ON. If the message is displayed
again, call your service provider.
Turn the power switch to Standby,
and then to ON.
Also, check the correct interface ca-
ble being used.
If the message appears again, call
your service provider.
It is necessary to replace the print
module.
Call your service provider.
Turn the power switch to standby,
and then ON. If the message ap-
pears again, call your service provid-
er.
Check the board is installed correct-
ly. If the message appears again, call
your service provider.
Enter the correct password.
Load the indicated tray with the pa-
per or select another tray using
{Form Feed}, or cancel the job.
Load the tray with the correct paper
or change the paper type/size using
the dial or using the Paper Input
menu on the operation panel. Alter-
natively, select another tray using
{Form Feed}, or cancel the job.
The printer displays this alert mes-
sage for 2 seconds before returning
to the previous panel display screen.
91