Ricoh Aficio AP900 Operating Instructions Manual page 50

Configuration
The wep setting menu appears.
WEP Setting:
*Not Active
Q
Press the {U} or {T} key to display [Active], and then press the {# Enter}
key.
The wep setting menu appears on the display.
Change WEP Key:
Yes (HEX)
❒ If the WEP setting is [Active], you must enter the WEP key.
❒ If you have entered the WEP key and changed the setting, press the {U}
or {T} key to display [No], and then press the {# Enter} key.
R
Press the {U} or {T} key to display [Yes (HEX)] when inputting a hexadec-
imal WEP key or [Yes (ASCII)] when inputting an ASCII WEP key. Then
press the {# Enter} key.
The wep key menu appears.
WEP Key:
k
The value in brackets at the upper right is the number of characters entered.
S
Press the {U} or {T} key to select characters, and then press the {# En-
ter} key.
You can now enter the next character.
Continue entering.
❒ When using 64 bit WEP, up to 10 characters can be used for hexadecimal
and up to five characters for ASCII. When using 128 bit WEP, up to 26
characters can be used for hexadecimal and up to 13 characters for ASCII.
❒ The number of characters that can be entered is limited to 10 or 26 for
hexadecimal and 5 or 13 for ASCII. If you try to enter too many characters,
the following message appears:
• hexadecimal
Error: Enter 10
or 26 characters
[ 0]
50