Ricoh Aficio AP900 Operating Instructions Manual page 90

Troubleshooting
Messages/Second mes-
sages
Close Finisher
Front Cover
Close
Front Cover
DHCP assigned
Cannot change
Empty Punch
Receptacle
Error: Tray #
Form Feed
Error: Enter 10
or 26 characters
Error: Enter 5
or 13 characters
Error:Tray #
Form Feed
Hardware Problem
Ethernet
Hardware Problem
Finisher
Hardware Problem
Fin. Shift Tray
Causes
The finisher front cover is
open.
The front cover is open.
An attempt to change the
IP address, subnet mask
or gateway address was
made while [DHCP] was
set to [On].
Punch hole receptacle is
full.
There is a problem with
the tray.
The entered number of
characters for the WEP
Key (ASCII entry) is incor-
rect.
The entered number of
characters for the WEP
Key (ASCII entry) is incor-
rect.
The selected tray is out of
order.
The printer detected an
ethernet error.
Finisher is not functioning. Turn the power switch to Standby,
The Finisher Shift Tray
has a problem when using
shift.
Solutions
Close the finisher front cover.
Close the front cover.
Make the change after setting [DHCP]
to [Off].
For details, see "Setting Printer",
Software Guide.
Remove the punch-hole chips from
the punch receptacle.
Alternatively, disable the punch set-
tings.
See p.129 "Removing Punch
Waste".
Turn the power switch to Standby,
and then to ON. If the message ap-
pears again, call your service provid-
er.
Enter the correct WEP key.
See p.47 "IEEE 802.11b (Wireless
LAN) Configuration".
Enter the correct WEP key.
See p.47 "IEEE 802.11b (Wireless
LAN) Configuration".
Select another tray using {Form
Feed}, or after cancelling the job, turn
Stand by and then turn on the power
switch. If the error appears again,
call your service provider.
Turn the power switch to standby,
and then ON. If the message ap-
pears again, call your service provid-
er.
and then to ON. If the message ap-
pears again, call your service provid-
er.
Call your service provider.
90