Using Tracks; Setting Up A Track - Raymarine 435i Owner's Handbook Manual

82

5.7 Using Tracks

The TRACK function is used to mark an on-screen trail that the vessel has
followed, as if it had left a visible fixed wake.
While the track is turned on, it is recorded in the display unit's memory.
You specify the interval at which track points are made and a line is drawn
on-screen between each point. Up to 1000 track points can be saved.
The track remains on-screen, even following a Power off/on, until the
track is cleared.
Using the SmartRoute function, a track can also be converted to and
saved as a route which is automatically reversed, ready for use as a return
voyage.
This section describes how to:
•
•
•
➤
To access the track controls:
1. Press the PAGE key to display the chart set up function bar:
2. Select TRACK SET UP to display the Track function bar:
The following instructions assume that the track functions are displayed.

Setting up a Track

Use the track functions to switch the track on and to specify the interval at
which track points are placed. The time interval between track points can
be set to 1s, 10s, 30s, 1min, 10min or 30min. The distance spacing
between track points can be set to 0.05nm, 0.1nm, 0.5nm or 1nm. The
maximum track length is 1000 points. When this limit has been reached,
track points continue to be placed, but the oldest points start to be deleted.
Set up a track and specify the interval between track points
Clear the current track
Convert the track to a route (SmartRoute)
RC435 and RC435i Chartplotters
D4694_1
D4695-2