Chapter 2: Installation
2.6 System Check and Initial Switch On
When installation is complete and all connections have been made, re-
check the installation before using the system for navigation. If problems
occur, refer to Chapter 6:Maintenance & Troubleshooting.
EMC Conformance
Always check the installation before going to sea to make sure that it is
not affected by radio transmissions, engine starting, etc.
System Check
Before performing the functional test, check that:
•
•
Initial Switch On
To switch on the chartplotter, press the POWER key.
If necessary, adjust the lighting and contrast (see Chapter 4).
If desired, change the default language settings as follows:
1. Press the PAGE key to display the setup function bar.
2. Using trackpad left/right, select the SYSTEM SET UP function and press
Figure 2-4: System Set Up Menu
All connections are clean and tight
All cables are secured and protected
ENTER. The SYSTEM SET UP menu is displayed, listing the parameters
and their current settings:
SYSTEM SET UP
D6247-3
19