Raymarine 435i Owner's Handbook Manual page 67

Chapter 5: Operation
➤
To make a new route by placing waypoints:
Note: You can pan the chart and change the scale while placing way-
points.
1. If necessary, move the cursor to the desired area in which to make the
2. Select ROUTES then MAKE ROUTE. The MAKE ROUTE function is
3. Move the cursor to the position on the chart where the first waypoint
Note: You can place the cursor on an existing waypoint, if desired; the
PLACE WAYPOINT function changes to USE THIS WAYPOINT. Press ENTER
to use the waypoint.
The waypoint appears on the screen at the cursor position. The number
displayed alongside the waypoint identifies its position in the route.
Note: If the route is Cleared before it is saved, the waypoint is removed.
4. Move the cursor to the next waypoint position; a dotted line connects
5. Press ENTER again. The next waypoint is placed and the dotted line
Note: If the waypoint was placed incorrectly, it can be deleted by press-
ing CLEAR. Successive waypoints can be deleted in this way.
6. Repeat Step 4. and Step 5. until all waypoints have been placed. Up to
7. When all your waypoints have been entered, press the GOTO key to
8. Select MORE to access the SAVE ROUTE function, or CLEAR to return
Note: The completed route is stored in the unit's memory and will be re-
displayed if the unit is switched off and on again. However, Raymarine
recommends that you save the route as described below. The current
route waypoints do not appear in the waypoint list until the route is saved.
route and select a suitable chart scale.
replaced with PLACE WAYPOINT, together with help text:
is to be placed and press ENTER.
the cursor to the last placed waypoint.
changes to a solid line.
50 waypoints can be included in a route. Any existing waypoint(s)
can be included by placing the cursor on the waypoint(s).
complete the route. The route is displayed on screen and is the current
route but is not active, that is, not being followed.
to chart mode.
57
D4679-1