Using Tracks - Raymarine GPS Plotter Owner's Handbook Manual

3-38
•
Receiving Waypoints from Other Equipment
➤
To receive incoming waypoints on SeaTalk or NMEA:
1. Display the Waypoint List by pressing MARK followed by the WAY-
2. Press the soft key RECEIVE WPTS FROM ST/NMEA ; the soft key
3. To disable waypoint transfer, press the soft key STOP RECEIVING WAY-
Note: Where multiple waypoints have the same position, the last way-
point sent is the only one included in the Waypoint List.
Sending Waypoints to Other Equipment
➤
To send the Waypoint List on NMEA:
1. Display the Waypoint List as previously described, then press the
2. Press the SEND WPT LIST ON NMEA soft key; the soft key changes to

3.7 Using Tracks

The Track function is used to mark, on-screen, the trail that your vessel
has followed, as though it had left a visible fixed wake.
When this option is selected, any waypoints received on SeaTalk or
NMEA are transferred and appended, one-by-one, to the Waypoint
List. Routes received on NMEA are appended to the Route List.You
can use this function to add waypoints from a PC connected via
NMEA.
You can send the Waypoint and Route Lists from the display unit to
other instruments via NMEA using the SEND WPT LIST function.
Sending the Waypoint List does not affect current routes. The
NMEA link could be to a PC.
POINT LIST soft key.
Press the WAYPOINT TRANSFER soft key.
changes to STOP RECEIVING WAYPOINTS .
When waypoints are transmitted by other equipment they are added
to the Waypoint List on the display unit. Routes transmitted on
NMEA are appended to the Route List.
POINTS .
Alternatively, press CLEAR twice to close the Waypoint List.
WAYPOINT TRANSFER soft key.
STOP SENDING WAYPOINTS .
The Waypoint and Route Lists are transmitted from the display unit
to other equipment on NMEA.
Raynav 300 GPS Plotter