Go To A Port - Raymarine 435i Owner's Handbook Manual

Chapter 5: Operation
A temporary waypoint is placed at the cursor position and navigation
proceeds towards it. The temporary waypoint is shown as a square with a
dot in the center and is connected to the vessel's starting position by a
dotted line.
On arrival, the arrival alarm is sounded and the arrival pop-up box is
displayed. The dotted line is removed but the temporary waypoint
remains on screen until another GOTO or FOLLOW operation is started, or
the waypoint is removed.
Note: The temporary waypoint is not added to the waypoint list. If the
GoTo is stopped prior to completion or the temporary waypoint is
erased.

Go to a Port

You can navigate directly to the nearest port or to a selected port or
facility.
➤
To navigate directly to selected port:
1. Press the GOTO key, select MORE, and then GOTO PORT to display the
2. Use trackpad up/down to select the desired port and press ENTER to
A dotted line is drawn between the current vessel position and the target
waypoint which is placed at the port. The line remains fixed on the screen
as the vessel moves.
Bearing, Range and Cross Track Error are calculated for the target
waypoint in the same manner as for any other GoTo or Follow function.
On arrival, the arrival alarm is sounded and the arrival pop-up box is
displayed.
➤
To navigate directly to the nearest port or facility:
1. Press the GOTO key and select MORE and then GOTO NEAREST to dis-
2. Use trackpad up/down to select the desired destination and press
The operation is conducted in the same manner as for GOTO PORT above.
Port List.
start the GoTo, or CLEAR to cancel the operation.
play the list.
The list shows the eight nearest places where the selected facility
exists, in order of distance. The bearing and range (in selected units)
for each one is shown.
ENTER to start the GoTo, or CLEAR to cancel the operation.
71