Bracket Mounting; Panel Mounting - Raymarine 435i Owner's Handbook Manual

14

Bracket Mounting

The display unit can be conveniently mounted on a dash area, chart table,
bulkhead or deckhead. Mount the unit as follows:
1. Loosen the mounting bracket knobs and remove the bracket from the
2. Mark the locations of the bracket screw holes on the mounting sur-
3. Drill the holes where marked.
4. Use the screws supplied to fix the bracket at the marked locations.
5. Fit the unit to the bracket, adjust the display angle and tighten the

Panel Mounting

CAUTION:
Make sure that there are no hidden electrical wires or other items
behind the location before proceeding. Make sure that there is
sufficient rear access for mounting and cabling. Allow at least 6cm at
the right hand side of the display to enable chart cards to be inserted
and removed.
The RC435 can be panel mounted, using the panel-mounting kit
(accessory) available from your local Raymarine dealer. A mounting
template appears at the end of this handbook.
Note: The RC435i with Internal GPS antenna cannot be panel (flush)
mounted.
➤
Panel mount the unit as follows:
1. Check the selected location for the unit. A clear, flat area at least
2. Using the supplied template, trace the unit cut-out and mark the drill-
3. To provide start holes for removing the cut-out, drill four 10mm
4. Using a suitable saw, cut along the inside edge of the cut-out line.
5. With the mounting bracket and knobs removed, make sure that the
6. Drill out the four 5mm (
display unit.
face.
knobs.
185mm (7¼ in) wide by 185mm (7¼ in) high, with at least 120mm
(4¾ in) of clearance behind the panel, is required.
ing centers for the four securing holes outside of the cut-out area.
( 3 in) holes in each opposing corner.
/
8
unit fits in the cut-out area.
plate. It is recommended that a 1mm
3 in) securing holes as indicated on the tem-
/
16
1 in) pilot hole is drilled first.
( /
16
RC435 and RC435i Chartplotters