Related Manuals for Flavel Caress Slimeline SC FNVC**SN
Summary of Contents for Flavel Caress Slimeline SC FNVC**SN
- Page 1 Caress Slimline SC COAL EFFECT GAS FIRE User Instructions Hand these instructions to the user Model No’s FNVC**SN is for use on Natural Gas (G20) at a supply pressure of 20 mbar in G.B. / I.E. ** denotes trim / fret variant...
-
Page 2: Installation Information
INSTALLATION INFORMATION CONDITIONS OF INSTALLATION It is the law that all gas appliances are installed only by a competent (e.g. CORGI Registered) Installer, in accordance with the installation instructions and the Gas Safety (Installation and Use) Regulations 1998. Failure to install appliances correctly could lead to prosecution. -
Page 3: Important Safety Information
ABOUT YOUR NEW FLAVEL MELODY The Flavel inset coal effect gas fire incorporates a unique and highly developed fuel bed which gives the realism of a loose coal layout combined with realistic flames and glow. The use of durable ceramic material in the construction of the fuelbed components ensures long and trouble free operation. -
Page 4: Operating The Fire
The hard ceramic fuel bed remains hot for a considerable period after use and sufficient time should be allowed for the fire to cool before cleaning etc. The fire must only be operated with the fender which was supplied with the product. -
Page 5: Spillage Monitoring System
To turn the fire off, FULLY raise the control lever to the OFF position. WARNING If the fire goes out for any reason or is turned off and it is necessary to relight the fire it is important to allow the fire to cool for 3 minutes before attempting to re-light it. -
Page 6: Assembling The Ceramics And Fuel Bed
ASSEMBLING THE CERAMICS AND FUEL BED NOTE : The position of the fuel-bed components are critical to the performance of the product. Therefore please ensure that the fuel-bed components are positioned as described in the following section prior to requesting a service call due to soot build up, poor flame pattern etc. Place the fuel-bed base centrally on to the fuelbed support and pull fully forwards to the burner. - Page 7 Place the right hand front coal rail moulding onto the front ceramic rail support as shown below in Fig. 3 Fig. 3 Fit four large coals behind the ceramic front rails as shown below in Fig. 4 Fig. 4...
- Page 8 Select three of the small coals and fit onto the ribs of the fuel-bed base. See fig. 5 below Fig. 5 Select the remaining four small coals and arrange along the rear of the fuelbed, directly behind the third row of coals. See fig. 6 below. Fig.
- Page 9 Ensure the coals sizes are correctly positioned as shown in Fig 7 below. “L” denotes “large” coals and “S” denotes small coals. If any coals are missing, please contact your retailer. Do not proceed with the installation. Fig. 7 Ensure the flame paths are un-interrupted as shown below in Fig. 8. If necessary, make minor adjustments to the coal positions to ensure the flame paths indicated by the arrows are available.
-
Page 10: User-Replaceable Parts
The part numbers of the user replaceable parts are as follows, these are available from your local Flavel stockist, who details may be found on the BFM Europe website, address shown on the back page. Fuelbed base... - Page 12 Due to our policy of continual improvement and development the exact accuracy of descriptions and illustrations cannot be guarantee Part no. B-118890 Issue 2 BFM Europe Ltd. Trentham Lakes Stoke-on-Trent Staffordshire ST4 4TJ www.bfm-europe.com Telephone - General Enquiries : (01782) 339000 Telephone - Service : (0844) 7700169...