Table of Contents
Advertisement
3.4.4
For Remote control model operation please see section 3.7
3.5
LIGHTING THE FIRE MANUALLY VIA THE CONTROL VALVE
3.5.1
These products can be operated manually by using the buttons directly
on the fire control in addition to the handset (should the need arise).
3.5.2
To operate the fire press and hold the "power" button as shown below
in figure 28 for two seconds, release as soon as the red indicator light
shown in figure 28 illuminates. The burner will then start its
ignition sequence and light to the maximum heat input level.For most
efficient performance leave the fire on high when lighting from
cold for ten minutes.
Fig. 28
Indicator light
Decrease
flame
3.5.3
To reduce the heat input, press and release the (-) button to lower the
heat input level one step at a time. Pressing the (-) button continuously
will move the heat input level to the minimum.
3.5.4
To increase the heat input level, press then release the (+) button to
increase the heat input level one step at a time. Pressing the (+) button
continuously will move the heat input level to the maximum.
3.5.5
To turn the fire off, press the power button and the burner will stop.
3.5.6
If you are not intending to use the fire for a long period (i.e.
over the summer months) the battery life can be extended by
sliding the power isolator switch to the left (to the "0" position
away from the "1" position) on the valve itself, which is located
behind the ashpan cover on the fire.
Power isolation switch
Increase flame
Power button
Battery compartment
cover opening lever
Battery
compartment
cover
28
Advertisement
Table of Contents
