Table of Contents
Advertisement
Appliance installation
1 Grip rail
2 Guide pin
3 Dotted line (perforation in the metal plate)
4 Guide groove
5 Positioning aid
»
Place the top appliance section onto the bottom appli-
ance section at the dotted line.
1 dotted line (perforation in the metal plate)
»
Slide the top appliance section towards the rear until
it is flush with the bottom section.
36
When the appliance sections are assembled correctly, the
end position is given by the guide groove and the guide pin.
»
Fasten the tabs at the front of the appliance.
»
Fit the thermal insulation element and the 4 hydraulic
hoses.
»
Fit the plug-in connectors of the 4 hydraulic connec-
tions. Ensure that the spring clips engage.
»
Plug in the heating sensor on the buffer tank.
»
Route the sensor cable in the guiding groove in the
thermal insulation element.
9.2
Installing the outdoor unit
9.2.1
Delivery and transportation
Note
Should you notice any transportation damage to
the appliance, you must report such damage im-
mediately when the delivery is unloaded. Claims
for transportation damage cannot be made sub-
sequently.
Material damage
»
Protect the appliance from damage by using
lifting slings.
»
When transporting, protect the appliance from
impact.
►
The standard packaging of the appliance does not
provide protection against the weather or sea water.
►
The appliance may be stored and transported only at
temperatures of between -20°C and +45°C.
►
The appliance must be stored in its transport
packaging.
►
When transporting with a crane, the outdoor unit must
be secured with two 8 m long ropes. Use strips of
fabric to protect the appliance from scratches.
www.ochsner.com | PIA-982043-AIR FALCON-T200-in-EN
Advertisement
Table of Contents
