Table of Contents
Advertisement
Galactic RGB 720
Operations
Main Menu
There are 3 available modes:
01) At start-up, once the calibration process has been completed and the device entered the currently
active mode, press the MENU control and hold it down for 2 seconds (do not turn the control).
02) You have entered the main menu in which you can choose whether you want to edit the device's
settings or to activate one of the built-in laser shows.
1. Mode
For detailed information on the available control modes, see page 19, chapter Control Modes.
2. Setting
01) While in the main menu, choose Setting by turning and then pressing the MENU control.
02) In this menu you are able to adjust the following options:
•
X mirror (the show flips horizontally)
•
Y mirror (the show flips vertically)
•
Color Setting (Single Color, R/G/Y - Red, Green, Yellow and Multicolor)
•
Scan Rate (The adjustment range: 0-20K. The higher the value, the more solid the laser beam
becomes.
•
Play Speed (available only in ILD mode. The adjustment range: 0-30. The lower the value, the
faster and smoother the animation)
03) To edit any of the forementioned parameters, select one of them by turning the MENU control to the
left or right.
04) Press the MENU control to enter edition mode.
05) Turn the MENU control to increase or decrease the value.
06) Once the changes have been made, press the MENU control to save.
Ordercode: 51340
Mode
Setting
Sensitivity
17
Advertisement
Table of Contents
