Table of Contents
Advertisement
Operating manual Pneumatic double diaphragm pump TOPFINISH DD10 Alu NiP
10 Repairs
10.3 TOOLS
The following tools are required for assembling and disassembling the device (if possible,
always bring entire tool sets with you):
Torque wrench with:
– Allen key
– Allen key
– Torx
10.4 CLEANING THE PARTS AFTER DISASSEMBLY
WARNING
Incompatibility of cleaning agent and working medium!
Risk of explosion and danger of poisoning by toxic gases.
4 Examine the compatibility of the cleaning agents and working media on the basis of
the safety data sheets.
Please note:
1. Thoroughly clean all reusable parts with a suitable cleaning agent.
2. All dismantled parts have to be clean and dry after cleaning. Care should be taken that
these parts remain free of solvents, grease or sweat from the hands (salt water). Perform
cleaning and mounting tasks wearing gloves.
10.5 ASSEMBLY OF THE DEVICE
In Chapter Spare Parts [8 53] the order numbers for device spare parts can be found, as
well as for wearing parts such as seals.
1. Defective parts, O-rings and seal sets must always be replaced.
2. Use greases and glues in accordance with Chapter Spare Parts [8 53].
3. Observe torque specifications in Chapter Spare Parts [8 53].
Assembly Aids
Order no.
Quantity
1 pc ≙ 50 ml
9992590
9992831
1 pc ≙ 50 ml
2396031
1 pc ≙ 10 gr
322912
1 pc ≙ 250 ml
Brand notice
The brands specified in this document are property of the respective owners. Loctite, for
example, is a registered brand of Henkel.
Order number DOC 2366672 | Edition 08/2020
SW 4
5 Nm; 3.68 lbft
SW 5
7 Nm; 5.16 lbft
10 Nm; 7.36 lbft
X20
1.5 Nm; 1.11 lbft
Designation
Loctite® 222
Loctite® 542
Grease
Hydraulic oil - Wagner
Smaller tanks
43
Advertisement
Table of Contents
