Table of Contents
Advertisement
Operating manual Pneumatic double diaphragm pump TOPFINISH DD10 Alu NiP
6 Assembly and Commissioning
Tighten the fastening screws regularly depending on the application conditions of the
pump. In the case of continuous or prolonged operation, it is advisable to check at least once
a week that there are no air and/or liquid leaks. The entire pressure regulator unit (1) can be
rotated 90 degrees to align the operating elements. For this purpose, the four screws (2)
must be removed.
1
2
6.5.1 Ventilation of the Spray Booth
– Operate the device in a spray booth approved for the respective working materials.
- or -
– Operate the device on an appropriate spraying wall with the ventilation (extraction)
switched on.
– Observe national and local regulations for the exhaust air speed.
6.5.2 Air Supply Lines
WARNING
Hose connections!
Risk of injury and damage to the device.
4 Do not mix up hose connections of product hose and air hose.
4 Ensure that only dry, clean atomizing air is used in the spray gun! Dirt and moisture in
the atomizing air worsens the spraying quality and spray pattern.
26
B_05371
Order number DOC 2366672 | Edition 08/2020
Advertisement
Table of Contents
