Repair Work; Repair Personnel; Repair Notes; Tools - WAGNER ZIP52 Translation Of The Original Operating Manual

VERSION 11/2018

10 REPAIR WORK

10.1 REPAIR PERSONNEL

Repair work must be carried out carefully and by qualified and trained personnel. They
should be informed of specific hazards during their training.
The following hazards may arise during repair work:
− Health hazard from inhaling solvent vapors.
− Use of unsuitable tools and aids.
A skilled person must check to ensure that the device is in a reliable state after it is repaired.
Carry out function test in accordance with Chapter 11.

10.2 REPAIR NOTES

DANGER
Incorrect maintenance/repair!
Danger to life and equipment damage.
Only a WAGNER service center or a suitably trained person may carry out repairs and
replace parts.
Use only WAGNER original spare parts and accessories.
Only repair and replace parts that are listed in the "Spare parts" chapter and that are
assigned to the unit.
Before all work on the device and in the event of work interruptions:
- Relieve the pressure from the spray gun, hoses and all devices.
- Secure the spray gun against actuation.
- Switch off the energy and compressed air supply.
- Disconnect the control unit from the mains.
Observe the operating and service manual for all work.
Before Repair Work
It should be ensured that the device is in the following state before carrying out any work
on it:
− Flush and clean the system.
− Interrupt the air supply.
− Depending on the operation, disconnect the product and air-side connection pipes.
− Remove the pump from the base or support it is fastened to.
After Repair Work
− Carry out safety checks in accordance with Chapter 8.2.3.
− Commission the system according to Chapter 6.7.
− Have the system checked for safe condition by an authorized person.
− Function test in accordance with Chapter 11.

10.3 TOOLS

The following tools are required for assembling and disassembling the device (if possible,
always bring entire tool sets with you):
– Torque wrench set
– Allen wrench set
ORDER NUMBER DOC 2330426
Chapter 8.1.2
ZIP 52/80
40