Table of Contents
Advertisement
VERSION 12/2017
10 REPAIR WORK
10.1 REPAIR STAFF
Repair work must be carried out carefully and by qualified and trained personnel. They
should be informed of specific hazards during their training.
The following hazards may arise during repair work:
− Health hazard from inhaling solvent vapors.
− Use of unsuitable tools and aids.
A skilled person must check to ensure that the device is in a reliable state after it is repaired.
Carry out function test in accordance with Chapter .
10.2 REPAIR NOTES
DANGER
Incorrect maintenance/repair!
Danger to life and equipment damage.
Only a WAGNER service center or a suitably trained person may carry out repairs and
replace parts.
Use only WAGNER original spare parts and accessories.
Only repair and replace parts that are listed in the "Spare parts" chapter and that are
assigned to the unit.
Before all work on the device and in the event of work interruptions:
- Relieve the pressure from the spray gun, hoses and all devices.
- Secure the spray gun against actuation.
– Switch off the energy and compressed air supply.
- Disconnect the control unit from the mains.
Observe the operating and service manual for all work.
Before a Repair
It should be ensured that the device is in the following state before carrying out any work
on it:
− Flush and clean the system.
− Empty pump according to Chapter 8.2.4.
− The air supply should be interrupted.
After a Repair
− Carry out safety checks in accordance with Chapter 8.2.3.
− Put the system into operation in accordance with Chapter
accordance with Chapter 11.
− Function test in accordance with section 11.
10.3 TOOLS
The following tools are required for assembling and disassembling the device (if possible,
always bring entire tool sets with you):
– Torque wrench with Torx 5 Nm; 3.68 lbft, 7 Nm; 5.16 lbft.
– Allen wrench set
ORDER NUMBER DOC 2366672
Section
8.1.2
TOPFINISCH DD10
6.7
and check for leaks in
36
Advertisement
Table of Contents
