Ecs Message Keys; Ecs Message Leds; Select Keys; Select Key Leds - Honeywell Farenhyt IFP-2000 Manual

151430-L8

11.2.1.3 ECS Message Keys

ECS Message Keys are used in Message Mode to select which ECS Message is to be played. If pressed when the
LOC does not have ECS Control, the system will automatically try to gain ECS Control before allowing the ECS
Event to be activated. See section 11.2.2.

11.2.1.4 ECS Message LEDs

The red ECS Message LEDs indicate the active ECS Message and any previously active ECS messages. The
green LEDs indicate the ECS Message was selected in message mode and that the LOC has ECS control.
1. For ECS Point Activation, the red ECS Message LEDs will illuminate on each LOC to indicate which ECS
messages have been activated in automatic ECS state.
2. In Manual ECS State, the red ECS Message LEDs will indicate which ECS message has been activated at an
LOC. See section 11.2.3.
3. The green ECS Message LEDs will activate for the LOC that activated the ECS Message.

11.2.1.5 Select Keys

The Select Keys are used to toggle which output areas are active.
1. If Message Mode is active (see Section 11.2.3), the Select Keys will activate output which areas for the
active message to be played in (also activates the red Select Key LED).
Note: For LOC activated emergency alarm events, if an area is programmed through mapping to be active that area is au-
tomatically selected and can not be deactivated using the Select Keys.
2. If Microphone Mode is active (see Section 11.2.3), the Select Keys will toggle which areas the microphone
audio is distributed to (also toggles the green Select Key LED).

11.2.1.6 Select Key LEDs

The Select Key LEDs are used to indicate which output areas are active for a microphone page (see Section
11.7.4.1) or system events.
1. Green LEDs: active areas for microphone paging.
Note: These are only active when the microphone PTT is engaged.
2. Red LEDs: active areas for system events.
Note: When system is Dual Channel Enabled, blinking indicates the area is active for an alert message.
Emergency Communication System Operation
11-2