Table of Contents
Advertisement
These instructions must be framed and displayed next to the IFP-2000 or ECS-RCU2000 panel
Operation
Silence Alarms
Press SILENCE then enter a code if prompted. Silence LED will light.
and Troubles
(Fire Only)
Reset Fire
Press RESET then enter a code if prompted.
Alarms OR
Reset ECS
Note: To reset ECS at an LOC, the user must gain ECS Control (See Figure 1).
Alarms
1.
Press RESET.
Reset Alarms
2.
Press 1 to Reset Fire System.
(ECS & Fire
3.
Press 2 to Reset Emergency Communication. System.
Active)
Note: To reset ECS at an LOC, the user must gain ECS Control (See Figure 1).
Hold the DRILL button and then enter a code if prompted. OR
1.
Enter the installer code. The panel will automatically go to the main menu.
Conduct a Fire
2.
Press 1 to select System Tests.
Drill
3.
Enter code if prompted, then press 1 to select Fire Drill.
4.
Press ENTER to start the fire drill, and Press ENTER to end the fire drill.
View Alarms,
For each type of condition, press the Up or Down arrow associated with Alarm, Supervisory, or Trouble.
Troubles, and
Supervisories
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Press 4 to select Set Time & Date. Enter a code if prompted.
Set Time and
3.
Make changes to the fields on the screen as necessary.
Date
4.
Press ENTER if you wish to keep the changes.
5.
Press ENTER to set the entered time and date.
1.
Enter the installer code. The panel will automatically go to the main menu.
2.
Press 2 to select Point Functions.
3.
Enter code if prompted, then press 1 to select Disable / Enable Point.
Enable / Disable
4.
Press 7 to select Disable/Enable Point.
a Point
5.
Select the module the point is located on by using the Up or Down arrow. Then press ENTER.
6.
Enter the point number then press ENTER.
7.
Press the right arrow to Disable/Enable Point.
To Gain /
1.
Press the
Request ECS
Control
Note: When ECS Control LED is blinking, another LOC has ECS Control. ECS Control LED is on steady when the
For Service call:
P/N LS10049-001SK-E Rev B
Model IFP-2000ECS / ECS-RCU2000
Basic Operating Instructions
in accordance with NFPA 72 fire code for Local Protected Fire Alarm Systems.
FS = Fire System
ECS = Emergency Communication System
Button and follow the on-screen Instructions.
LOC has ECS Control.
Task to Perform
ECN: 13-0759
Advertisement
Table of Contents
Troubleshooting
