Honeywell Farenhyt IFP-2000 Manual page 176

151430-L8
Operation
Occurs When
Mode
A system trouble
condition occurs.
Trouble
A trouble
condition with a
CO detector
A single detector
trips in a 2-Count
zone. (2-Count
means two
Prealarm
detectors must
trip before an
alarm is
reported.)
The RESET
button is pressed
Reset followed by a
valid code, if
necessary.
Table 10-2: Operations Mode Behavior
System Behavior
The dialer seizes control of the phone line and
calls the central station.
The on-board annunciator sounds a loud,
pulsing beep in the sequence ¾ of second on,
eight seconds off.
SYSTEM TROUBLE LED is on.
The LCD displays a screen similar to this one.
Touchpad PZT beeps.
The LCD displays a screen similar to this one.
All LEDs are on briefly then the LCD displays
"RESET IN PROGRESS". If the reset process
completes normally, the date and time normal
mode screen displays.
Press down arrow to view the fire trouble. A screen
similar to this one displays.
Press SILENCE to silence the annunciator.
Once the trouble condition has been fixed, the
system will restore itself automatically.
After sitting idle, events will display in a screen similar
to this:
Press down arrow to view the Prealarm. A screen
similar to this one.
All system operations are available in this mode.
After sitting idle, events will display on a screen
similar to this:
Note: Alarm and Prealarm are combined into a single
alarm count.
Menus are not available during the reset process.
10-14
System Operation
In This Mode You Can