Saving The Configuration File - Quantum PX500 Series Upgrade Instructions

Quantum PX500 Series TC2201 Upgrade Instructions
81-81538-01 A01
December 2005
Figure 14 PX506 Series
Interconnect (6 drives)
Ethernet
cables from
TC2201 and
SCB to switch
SCB (system
controller
board)
Configuring the
TC2201 Bridge
0
Software
18
After the TC2201 is installed, you must configure the bridge and map the tape
drives and library robotics controller to the iSCSI port. Configuring the
TC2201 consists of the following steps:
• Accessing the TC2201 Bridge
• Configuring the TC2201 Bridge
•

Saving the Configuration File

Accessing the TC2201 Bridge
To configure the TC2201 bridge:
1 Open a web browser on the service PC.
2 In the field, type http://IPaddress/ where IP address is the IP
Address
address for the PX500 Series library (refer to the Quantum PX500 Series
User's Guide PN 81-81290-01 for information on the PX500 Series remote
management web pages).
TC2201 Upgrade Procedure
SCSI cable to
SCB
Ethernet switch
iSCSI bridge 1
iSCSI bridge 2
iSCSI bridge 3
SCSI cable to
from TC2201
to tape drives
Terminator
PX506 shown
0