Quantum PX500 Series Upgrade Instructions page 16

Quantum PX500 Series TC2201 Upgrade Instructions
81-81538-01 A01
December 2005
0
Installing SCSI Cables
Table 2 Cabling a TC2201
Bridge to the Tape Drives
16
Use the following procedure to connect the SCSI cables and terminators to the
tape drives and TC2201(s).
• SCSI connectors 0 through 1 on the first TC2201 are used to connect to
tape drives 0 through 1 and the library robotics controller.
• SCSI connectors 0 through 1 on the second TC2201 are used to connect to
tape drives 2 through 3, if present.
• SCSI connectors 0 through 1 on the third TC2201 are used to connect tape
drives 4 through 5, if present.
• SCSI connectors 0 through 1 on the fourth TC2201 are used to connect
tape drives 6 through 7, if present.
• SCSI connectors 0 through 1 on the fifth TC2201 are used to connect tape
drives 8 through 9, if present.
To cable a TC2201 bridge to the tape drive(s):
1 To connect the SCSI cables from the TC2201 to the tape drives, see
and figure 14.
Use care when handling the fibre optic cables. Do not
Caution:
crimp or bend the cables.
Tape Drive Connection/
System Controller Board
Ethernet port
iSCSI ports
SCSI port 0
SCSI port 1
System controller board (top
port)
System controller board
(bottom port)
Tape drive 1, lower port
Tape drive 2, upper port
TC2201 Upgrade Procedure
TC2201 Connections/ Tape
Drive Termination
Port 0 on first TC2201
Tape Drive 1, upper port
Terminator
Port 1 on first TC2201
table 2