Quantum PX500 Series Upgrade Instructions page 8

Quantum PX500 Series TC2201 Upgrade Instructions
81-81538-01 A01
December 2005
Installing the TC2201
0
Bridge
Figure 6 Installing a
TC2201 Bridge (PX502)
8
The number of TC2201 bridges required depends on the number of tape
drives installed in the library.
• 1 to 2 tape drives requires 1 TC2201
• 3 to 4 tape drives requires 2 TC2201 bridges (PX506 and PX510 only)
• 5 to 6 tape drives requires 3 TC2201 bridges (PX506 and PX510 only)
• 7 to 8 tape drives requires 4 TC2201 bridges (PX510 only)
• 9 to 10 tape drives requires 5 TC2201 bridges (PX510 only)
To install the TC2201 bridge:
1 Loosen the two PHILLIPS screws securing the blank off plate(s) to the
CPCI card cage and expose the number of slots needed for the TC2201
installation (one blank off plate per TC2201).
Start the TC2201 installation in slot 1 of the CPCI card cage
Note:
(PX506 and PX510 only).
2 With the SCSI ports located to your right as you face the back of the
library, slide the first TC2201 into the slot of the card cage (see
PX502, figure 7 for PX506, and
Screws
Card cage
TC2201
TC2201 Upgrade Procedure
figure 8 for PX510).
Blank off plate
figure 6 for