Quantum PX500 Series Upgrade Instructions page 13

Quantum px500: install guide

Hide thumbs Also See for PX500 Series:

Table of Contents

To install and cable the Ethernet switch:.

If the libraries are in a multiple stack configuration, mount the

Note:

Ethernet switch directly above the top-most library.

1 Refer to the Ethernet switch installation documentation to install the

switch into the rack.

2 Connect the following Ethernet cables:

•

One Ethernet cable from the right port on each library SCB to the

Ethernet switch.

•

One Ethernet cable from each TC2201 to the Ethernet switch.

3 Secure the Ethernet cables with cable clamps and tie bands as needed (see

figure 12

for unstacked configurations and

configurations).

The Ethernet switch shown in the following figures

Note:

and

figure

TC2201 Upgrade Procedure

Quantum PX500 Series TC2201 Upgrade Instructions

figure 13

13) is only an example.

81-81538-01 A01

December 2005

for stacked

(figure 12

Table of Contents

Px502 Px506 Px510 Tc2201