Quantum PX500 Series Upgrade Instructions page 12

Quantum PX500 Series TC2201 Upgrade Instructions
81-81538-01 A01
December 2005
Installing the Ethernet
0
Cables
Figure 11 PX502 Ethernet
Connection
SCB (right port)
12
Depending on the library type, one or more Ethernet connections must be
made to the TC2201 iSCSI bridge. Refer to the following section for your
specific library:
• PX502 Ethernet Connections
• PX506 and PX510 Ethernet Connections
PX502 Ethernet Connections
PX502 libraries with installed TC2201 iSCSI bridges must have the following
Ethernet connections:
1 Connect a cross-over cable between the right port of the library system
controller board (SCB) and the TC2201 (see
Cross-over cable
PX506 and PX510 Ethernet Connections
PX506 and PX510 require an Ethernet switch if more than one TC2201 is
installed in the library. Use the following procedure to install the Ethernet
switch and connect the Ethernet cables.
If your PX506 or PX510 libraries have only a single TC2201 iSCSI
Note:
bridge, refer the
cross-over cable is connected between the library SCB and TC2201.
TC2201 Upgrade Procedure
figure
TC2201
PX502 Ethernet Connections. A single Ethernet
0
11).
0