Saving The Configuration File; Enabling Serverless Backup (Xcopy) - Quantum PX500 Series Upgrade Instructions

Figure 14 PX506 Series
Interconnection (6 drives)
Ethernet
cables from
FC1202 and
SCB to switch
SCB (system
controller
board)
Configuring the
FC1202 Bridge
0
Software
After the FC1202 is installed, you must configure the bridge and map the tape
drives and library robotics controller to the Fibre Channel port. Configuring
the FC1202 consists of the following steps:
• Accessing the FC1202 Bridge
• Configuring the FC1202 Bridge
•

Saving the Configuration File

•

Enabling Serverless Backup (Xcopy)

Accessing the FC1202 Bridge
To configure the FC1202 bridge:
1 Open a web browser on the service PC.
FC1202 Upgrade Procedure
Quantum PX500 Series FC1202 Upgrade Instructions
SCSI jumper to
SCB
81-81351-01 C01
April 2006
Ethernet switch
FC bridge 1
FC bridge 2
FC bridge 3
SCSI jumper to
from FC1202
to tape drives
Terminator
PX506 shown
0
19