2.23.4 Built-in FOS Interface
Description
You can connect a FOS system (Front Office Software) for use in hotels directly to the PBX.
Conditions
•
KX-NSF101 (CTI interface) or KX-NSA020 (CSTA Multiplexer) is required to use this feature.
•
This feature cannot be used if this PBX is a member of a One-look network.
•
The built-in FOS interface supports the following commands:
FOS ® PBX
–
Link Alive
–
Link Start
–
Check In/Check Out
–
Message Waiting On/Off
–
Do Not Disturb Set/Clear
–
Wakeup Time Set/Clear
–
Change COS
–
Room Sharing/Guest Change
–
Post Answer
PBX ® FOS
–
Link Alive
–
Link Start
–
Link Setup
–
Station Message Detail Recording/Call Charge Posting
–
Room Status
–
Minibar Charge Posting
–
Wakeup Confirmation OK/NG
–
Message Waiting On/Off
–
Do Not Disturb Set/Clear
•
When a Change Cos command is received from the FOS system, the built-in FOS interface converts the
COS number from the FOS system to an internal COS number as follows:
COS number (FOS)
COS number (PBX)
•
If communication with the FOS system is interrupted, the PBX will record data on SMDR. When
communication is re-established, the PBX will send the recorded data to the FOS system.
PC Programming Manual References
9.2.2 PBX Configuration—[1-1] Configuration—Slot—System Property—Site—Port Number
0
1
1
2
2.23.4 Built-in FOS Interface
2
3
3
4
Feature Manual
283