Panasonic KX-NS700 Feature Manual page 247

[Other Panasonic SLTs with a Message feature]
•
Programming is not required to use this feature.
•
Message Waiting Lamp is supported by the FSK signal. The SLT cards that support Message Waiting
Lamp (FSK) are as follows:
–
MCSLC4 (installed by default)
–
MCSLC8 (KX-NS5173)
–
MCSLC16 (KX-NS5174)
[SIP Phones]
•
To use this feature, it must be enabled for each extension port through system programming. (®
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—Option 8—
MW Mode)
•
Only Standard type or Unsolicited type general SIP extensions can control message waiting indication
LEDs. To change the message waiting indication method, refer to 9.16 PBX Configuration—[1-1]
Configuration—Slot—Port Property—V-SIPEXT—
PC Programming Manual References
9.16 PBX Configuration—[1-1] Configuration—Slot—Port Property—V-SIPEXT
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—
Cancel / Call Back
10.6.3 PBX Configuration—[2-6-3] System—Numbering Plan—B/NA DND Call Feature—
Set
10.9 PBX Configuration—[2-9] System—System Options—Option 3—
10.9 PBX Configuration—[2-9] System—System Options—Option 5—
12.1.1 PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—Option 8—
Mode
12.1.4 PBX Configuration—[4-1-4] Extension—Wired Extension—Flexible Button—
12.2.3 PBX Configuration—[4-2-3] Extension—Portable Station—Flexible Button—
Feature Manual References
2.21.2 Flexible Buttons
3.2 System and Subscriber Features
6.1 Capacity of System Resources
Operating Manual References
1.2.4 When the Dialled Line is Busy or There is No Answer
1.8 Using the Unified Messaging Features
MWI Method.
Dial Tone—Distinctive Dial Tone
SLT—Message Waiting Lamp Pattern
2.20.1 Message Waiting
SLT
Message Waiting Set /
Message Waiting
SLT MW
Type
Type
Feature Manual 247