Test Menu 1: Communication Test - Mitsubishi Electric ME96SSHA-MB User Manual

4. Using Test Mode

4.1. Test Menu 1: Communication Test

In the setting value confirmation mode, when the menu number is set to "9", you will enter the test mode.
Test menu
①Communication test
Test menu
Set the test menu number to "1".
(as shown in the right figure)
Execute communication test operation.
(Values other than zero can be monitored even when the voltage and current are not input.)
■
Monitor value by communication
・
Values displayed on the screen,can be monitored.
Measurement elements not displayed on the screen are zero.
(only power factor is 1.000).
・ If you set the Alarm item with Setting Menu 5, the display will be the same as
the alarm is generating.
（If you are using the ME-4210-SS96, alarm contact will remain open.）
・ It is possible to monitor the digital input status.
■
Display screen
■
Button operation
Operation
Press
Press
Press
Press or
Press and
together for at least 2 seconds.
Press
Note: When executing a communication test, please read the following manual
in addition to this instruction manual. (For more information refer to page 102.)
･Electronic Multi-Measuring Instrument ME Series MODBUS® Interface specifications
･Electronic Multi-Measuring Instrument Programming Manual (CC-Link communication)
<To continue other test mode>
⇒
Select other test menu number and then press
<To close test mode>
⇒
Select "End" as the test menu number and then press
You will return to the operation mode.
・
As with the operation mode, it is displayed according
to settings such as the display pattern.
・
The maximum/minimum value can be displayed.
(Cyclic display cannot be executed.)
Switches the display screen.
Switches the phase.
Moves or returns to the maximum/minimum
value screen.
Switches the analog bar graph element.
Switches the harmonic degree (when
harmonics screen is displayed).
Change the unit of Wh, varh and VAh.
Return to the test menu.
.
58
Function
.
SET