Mitsubishi Electric ME96SSHA-MB User Manual page 31

3. Setting
3.5. Setting Menu 2: Communication Settings (Setting the MODBUS
④
MODBUS®TCP
Default gateway
existence
DISPLAY
®
⑤MODBUS
TCP
Default gateway
address
⑥Communication
reset
Setting Menu
Set the Default gateway existence.
If the default gateway exists on the Ethernet,
select "on" to communicate with other network.
oFF
Set the Default gateway address.
If select "oFF" in ④MODBUS®TCP Default gateway existence,
this display will be skipped.
000.000.000.000 to 127.0.0.1 to 255.255.255.255
* If invalid default gateway address is set, error code E05
is appears.
If that happens, press
the default gateway address.
The following default gateway addresses cannot be configured.
・0.0.0.0
・xxx.xxx.xxx.255 (xxx are any values)
When the changed above settings of MODBUS® TCP are enabled,
set to "on."
（When it is not set to "on," the changed settings of MODBUS®TCP
do not become effective.）
oFF on
According to the setting flow (page 16 to 21), save the changed
contents, or continue to the other setting menu.
If it is needed to set the MODBUS®RTU communication setting,
Select the menu number "2" again, and select "Mb.rtu" at
①Communication setting selection.
on
and set again after review
30
® TCP communication)