Requirements - Intel AC450NX Product Manual

AC450NX Rack Server System Product Guide
Table 7-2. EMP Console Access Modes (Server not configured for console redirection)
Mode Server is powered off
Disabled Redirect window appears,
but is blank
Pre-boot EMP commands available
Always Active EMP commands available

Requirements

This section outlines the requirements and configurations necessary for using EMP Console.
Operating Systems:
•
Windows 95
 16 MB of RAM, 32 MB recommended
 20 MB disk space
•
†
Windows NT
 Windows NT 4.0
 24 MB of RAM, 32 MB recommended
 20 MB disk space
Client Configuration: EMP Console supports all COM ports on the client system, along with any
Windows NT/95 compatible modem.
Server Configuration: EMP Console requires the server's COM 2 port to be connected to an
external modem or directly connected to a serial cable.
Direct Connect Configuration: A null modem serial cable is needed. Connect one end of the
cable to the COM 2 port of server and the other to a port on the client machine.
Modem Configuration: On the client, EMP Console uses the Windows Application Program
Interface (API) to determine if a modem is connected and available. The EMP Console does not
configure the modem; it should be preconfigured through Windows.
For modem support, the server must use a Hayes compatible modem that supports a baud rate
of 19.2k. The modem must be on the NT Hardware Compatibility List provided by Microsoft.
The server modem must be set in auto-answer mode for EMP Console to be able to connect to it.
80
During POST
Redirect window appears,
but is blank
EMP commands available
EMP commands available
After OS boots
Redirect window appears,
but is blank
Redirect window appears,
but is blank
EMP commands available