Advanced Menu (continued)
Feature
Option
Serial Port B
Disabled
Enabled
Auto
Base I/O Address
3F8
2F8
3E8
2E8
Interrupt
IRQ3
IRQ4
Parallel Port
Disabled
Enabled
Auto
Mode
Output only
Bidirectional
EPP
ECP
Interrupt
IRQ5
IRQ7
Diskette Controller
Disabled
Enabled
Auto
Base I/O Address
Primary
Secondary
Advanced Chip Set
Control
Address Bit Permuting
Disabled
Enabled
Card to Card
Disabled
Interleave
Enabled
Chapter 4 Setup Utility: When to Run
Description
Configure serial port B using these options:
•
Disabled—no configuration.
•
Enabled—user configuration.
•
Auto—BIOS or OS chooses the configuration.
•
OS Controlled—displayed when controlled by
the OS.
Set the base I/O address for serial port B.
Set the interrupt for serial port B.
Configure the parallel port using these options:
•
Disabled—no configuration.
•
Enabled—user configuration.
•
Auto—BIOS or OS chooses the configuration.
•
OS Controlled—displayed when controlled by
the OS.
Set the mode for the parallel port.
Set the interrupt for the parallel port.
Configure the diskette controller using these options:
•
Disabled—no configuration.
•
Enabled—user configuration.
•
Auto—BIOS or OS chooses the configuration.
•
OS Controlled—displayed when controlled by
the OS.
Set the base I/O address for the diskette controller.
Enabled automatically sets two-way or four-way
permuting based on the memory configuration. Enabled
requires:
•
number of rows to be a power of two.
•
all rows to be the same size.
•
all populated rows to be adjacent and start at row 0.
Enabled requires a symmetric RAM configuration
between two memory modules.
continued
49