Table of Contents
Advertisement
Derby LED
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a solution is found. Once the unit
operates properly, do not carry out following steps.
No Light
If the light effect does not operate properly, refer servicing to a technician.
Response: Suspect three potential problem areas as: the power supply, the lamp, the fuse.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The LEDs. Return the Derby LED to your Showtec dealer.
03) The fuse. Replace the fuse. See page 8 for replacing the fuse.
04) If all of the above appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the Derby LED, as this may
damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Product Specifications
Model
Input Voltage:
Power consumption:
Fuse:
DC motor：
Dimensions:
Weight:
Electro-mechanical effects
●
Sound-controlled through a built-in microphone
●
Colors: Red, Green and Blue
●
Light source: 2x 9 Watt 3 in1 RGB LED Chip
●
Music activated colourchanger effect
●
Plug & Play
●
Chip on board
●
When no music is played the LEDs and DC Motor turn off after 10 seconds
Max. ambient temperature t
Max. housing temperature t
Minimum distance
Minimum distance from flammable surfaces:
Minimum distance to lighted object:
Design and product specifications are subject to change without prior notice
j
Ordercode: 43041
Showtec Derby LED
AC 100-240V - 50/60 Hz
30W
1A/250V
DC 12V 70 rpm
430 mm x 390 mm x 210 mm (LxWxH)
6,5 kg
:
40°C;
a
:
80°C
B
0.5 m
0.8 m
Website:
www.Showtec.info
Email:
service@highlite.nl
9
Advertisement
Table of Contents
