Backside; Installation; Set Up And Operation - SHOWTEC Derby LED V2 Manual

Derby LED

Backside

Fig. 02
02) Safety eye
03) Audio Sensitivity
04) Fuse 1A/250V
05) Built-in microphone
06) Ground/Earth connection
07) Power cable 100-240V

Installation

Remove all packing materials from the Derby LED. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Ordercode: 43041
7