Table of Contents
Advertisement
For a higher heat level slide the button upwards. The burner flames and heat output
K
will gradually increase until the button reaches the high heat position shown in figure 2.
When the button reaches the high heat position you will feel a check to its movement. Do
not slide the button above the high heat position unless you want to turn the fire off
(See note i).
Note
i.
If the flames go out while setting the control, repeat the full lighting procedure. If
the flames repeatedly go out have the fire serviced.
ii.
When first turned on the flames will appear predominantly blue. The coals will
take time to warm up. Although some glow will be seen after approximately ten minutes,
the full visual effect will only be apparent after a somewhat longer time.
iii.
The appliance will operate to its maximum potential if the flue is primed during
the first 20 – 30 minutes of operation. To do this, simply slide the control to its highest
setting. This will also burn off any carbon deposits that may have formed during previous
operations.
iv.
If operating the appliance for long periods it is beneficial to change between
settings. This will also help to remove any carbon deposits that may form during
operation.
To turn the fire off
Slide the button up past the high heat position to the "O" position until the flames
extinguish. Both the main burner and the pilot should go out.
While cooling, the coals may make some crackling noises. This is quite normal.
Lighting with a taper
See figure 3.
In the unlikely event of failure of the ignition spark, the pilot
can be lit by a taper or long spill. Insert the taper or spill
alongside of the left side of the fire box and operating the slide
control as described above.
OWNER'S GUIDE
Page 8
Figure 3 Lighting with
a taper
Advertisement
Table of Contents
