Toyotomi CTN/CTG-328W User Manual page 18

controller will exit the setting status automatically.
LIGHT
button
Press this button to control the LED status on the displayer, the circulation
change is as follow:
When selecting «
indoor unit will adjust the luminance automatically according to the ambient
intensity of illumination.
SLEEP
button
Press this button, can select Sleep 1 (
cancel the Sleep, circulate between these, after electrifi ed, Sleep Cancel is
defaulted.
Sleep 1 is Sleep mode 1, in Cool modes; sleep status after run for one hour, the
main unit setting temperature will increase 1 , two hours, setting temperature
increased 2 , then the unit will run at this setting temperature; In Heat mode:
sleep status after run for one hour, the setting temperature will decrease 1 ,
two hours, setting temperature will decrease 2 , then the unit will run at this
setting temperature.
Sleep 2 is Sleep mode 2, that is air conditioner will run according to the
presetting a group of sleep temperature curve.
Sleep 3 the sleep curve setting under Sleep mode by DIY.
(1) Under Sleep 3 mode, press «HEALTH» button for a long time, remote
controller enters into user individuation sleep setting status, at this time,
the time of remote controller will display «1hour», the setting temperature
«88» will display the corresponding temperature of last setting sleep curve
and blink
(The fi rst entering will display according to the initial curve setting value of
original factory).
(2) Adjust « + » and « - » button, could change the corresponding setting
temperature, after adjusted, press «HEALTH» button for confi rmation.
(3) At this time, 1hour will be automatically increase and ed at the timer position
on the remote control, (that are «2hours» or «3hours» or «8hours»),
the place of setting temperature «88» will display the corresponding
temperature of last setting sleep curve and blink.
no display
LED on LED off Auto LED
» (Auto LED) with remote controller, LED indicator on
18
no display
LED off
), Sleep 2 ( ), Sleep 3 ( ) and
GB