Toyotomi CTN/CTG-328W User Manual page 40

NOTE:
• Add insulating pipe in the indoor drain hose
in order to prevent condensation.
• The plastic expansion particles are not
provided.
Step 7: Connect wire of indoor unit
NOTE:
• All wires of indoor unit and outdoor unit should be connected by a
professional.
• If the length of power connection wire is insuffi cient, please contact the
supplier for a new one. Avoid extending the wire by yourself.
• For the air conditioner with plug, the plug should be reachable after fi nishing
installation.
• For the air conditioner without plug, an air switch must be installed in
the line. The air switch should be all-pole parting and the contact parting
distance should be more than 3mm.
1. Open the panel, remove the screw on
the wiring cover and then take down the
cover.
2. Make the power connection wire go
through the cable-cross hole at the
back of indoor unit and then pull it
out from the front side.
3. Remove the wire clip, connect the power connection wire to the wiring
terminal according to the color, tighten the screw and then fi x the power
connection wire with wire clip.
cable-cross
hole
power connection
wire
40
drain hose
insulating pipe
screw
panel
wiring cover
GB